CASE STUDY: EZ Burr visits GM Romulus deburring internal ribs in a very long engine block.
The speed & feed is 1250 RPM @ 400 mm/min.; cycle time 12-15 seconds. EZ Burr had to make an extra length tool that could handle these cutting conditions without adding any cycle time to the process. The insert had to produce a clean, smooth surface and run a consistent number of blocks each and every shift.
0 Comments
Leave a Reply. |
ABOUT
This is where we publish technical articles, applications stories, tip and tricks, new product announcements and press releases. Archive
March 2021
Categories
All
|